Pictures of the P.C.A.V. installed on a 1956 Ford F100

(Click Pictures To See Full Size)

(Picture of 1956 Ford F100 Adapter Plate)

1956 Ford F100 P.C.A.V (Gen II)


This is a complete kit that motorizes the cowl air vent on 1956' Ford classic trucks, by eliminating the manual handle and linkage and replacing it with a 12-volt actuator.

Perfect for use with center mount a/c units. Easy to install, Direct Bolt-On, Pre-wired and water proof.

This complete kit comes with everything need to operate the cowl air vent up and down; Actuator, Switch, Wiring, Battery Terminals, Fuse, Mounting Perch, Hardware and 1956 Ford Adapter Plate.

Gen II includes; 5/16" Mounting Bolts, Nuts and Lock washers; Thicker Mounting Washers; Copper Battery Terminals; Low amp Fuse.

(Click Picture To See Full Size)


  • Download Our PDF Install Manuel of The 1956 Ford P.C.A.V.
    (Left click to view, right click the link and click "save link as" to download.)

  • Download Our Install Video of The 1956 Ford P.C.A.V.
    (Left click to view, right click the link and click "save link as" to download.)

  • The actuator -

    Lift: 900N

    Power: 12v

    Duty Cycle: 10%

    Note: Actuator is Pre-wired to switch, has internal limit switches and water proof seals.

    (Click Picture To See Full Size)


    Actuator Dimensions

    (Click Picture To See Full Size)

    The Switch - the 3 position momentary switch on/off/on is pre-wired to the actuator. Includes all hardware to mount in dash or unused choke hole

    (Click Pictures To See Full Size)

    The Mounting Bracket - The bracket Comes pre-drilled and galvanizes so it will not rust or oxidize, All bolts, nuts, carter pins included And a Mounting Adapter Plate (for 56' ford only).

    (Click Picture To See Full Size)

    In-line Waterproof Fuse Holder with 10 amp fuse.



    (Click Pictures To See Full Size)




    - Special Website Only Offer! - (2)-1156 and (2)-1157 LED Turn/Brake Bulbs Free! - With Power Cowl Kit Perches -


    (Click Picture To See Full Size)

    12v Power Cowl Air Vent 1956 Ford Truck (Gen II)

    This kit comes with everything to operate the cowl vent on 12 volts, including; actuator, switch, wiring, battery terminals, fuse, mounting perch, hardware and 1956 Ford Adapter Plate.

    This kit is designed to work on 12 volts only.

    Each kit has its own stamped Millstone Automotive serial number.

    We manufacture and assemble here in the USA. We test every component and complete kit before we ship.

    Professional Packing and UPS shipping only.


    PayPal Acceptance Mark
    1956 Ford F100 Power Cowl Air Vent Kit (Gen II)
    $139.95 + shipping, Pay-Pal Check-Out


    Includes (2)-1156 and (2)-1157 LED Turn/Brake Bulbs Free! - With Power Cowl Kit Perches



    Feel free to email us on our Contact Us page.